One recovery image is provided for the recovery of a MX-ONE Service Node Mitel ASU Lite or Mitel ASU-II.
SW RAID 1 is used if Mitel ASU-II have two hard disc drives. SW RAID 1 is not supported together with Cassandra DB.
Boot the server from the USB.
Press F3-key to change display resolution to 800X600.
Select Installation from the menu. If no selection is made in the boot choice menu the default installation type is executed automatically, for example, boot from hard disk.
The installation starts installing LINUX and the MX-ONE Service Node software during approximately 25-30 minutes. After installation is complete the message “Please Reboot System now” will be shown.
Logon as user root with password changeme, then type command reboot and press Enter. Wait for system to reboot.
The server is now in the same default status as it was when delivered from the factory (Turnkey).
Select Yes when the following message is displayed: Welcome to MX-ONE. You have to configure your system before starting the MX-ONE. Do you want to configure your server now?
Continue with installation and configuration of the system, see the installation instructions for INSTALLING AND CONFIGURING MIVOICE MX-ONE section NETWORK AND SYSTEM CONFIGURATION.