Recovery Image Installation

To install the recovery image, perform the following steps:

OS Install
  1. Boot the machine from the storage media with Recovery Image.
  2. Enter BIOS mode.
  3. Change the date if necessary. Other parameters might also need to be modified (Set Time Zone).
  4. If USB is used, make sure that the boot order is: Hard disk, USB.
  5. Re-boot the machine from the storage media.
  6. At the initial screen select the “Install” option. Press Enter.
    Note:

    If the partitioning fails, the disk is not clean. Use the FDISK utility to partition the disk. For example, run fdisk from a Linux Live-CD.

    Note:

    Beware of the timeout when the first screen appears. In case no selection is made, the system will boot with default parameters and the configuration file will not be read.

  7. Log on as root. (Default password is set to "changeme". Change it during the installation.)
  8. Restart the server by typing reboot at the shell prompt.
  9. The OS is now installed on the server HW.
  10. Repeat for all servers as necessary.

MX-ONE Service Node Install

To start the installation of MX-ONE, login as root and start the installation with command /sbin/net_setup. See chapter, Network and System Configuration for details. This will setup the network and start the installation. Always start from Server1.