Configure the Media Gateways

For the MX-ONE Service Node to be able to communicate with its media gateway it must know the IP address of the media gateway control port, eth0. If needed, it must be set on the media gateway hardware. If link-failover is used, then required link-failover mode shall be selected.

There are two major types of MX-ONE media gateways:
  • The media gateway built around the MGU board.

    For instructions on how to set the IP address, to be able to reach the MGU hardware over the network, and link-failover mode, see MGU Board Setup.

  • The MX-ONE Media Server, is a pure software implementation which emulates the MGU board (except for the TDM interfaces). This media gateway can only be used for SIP-only scenarios.

    For instructions on how to configure the MX-ONE Media Server, see the description of MX-ONE Media Server.

Parent topic: Completing the Configuration
↑