Remove Board

Be very careful not to remove the server until it has been properly powered down, as described here.

1. Stop the system fault supervision.

   Key command recoverymode -manual.

2. Block all traffic to the unit.

   Key command blocking -i.

   If the ASU, Mitel ASU Lite or Mitel ASU-II or Mitel ASU-III is malfunctioning (not responding to commands) go to step 5.

3. Has all traffic ceased? When the traffic has ceased continue with the next step.

   Key command switch_connection_list.

4. Shutdown the Server.

   Root privilege is needed. Wait for the system to stop, which is indicated by the green LED or LEDs on the front of the server turning off.

   Key command shutdown -h now.

5. Note how the cables are connected on the front of the ASU, Mitel ASU Lite or Mitel ASU-II or Mitel ASU-III. Then remove them.

6. Pull out the ASU, Mitel ASU Lite or Mitel ASU-II or Mitel ASU-III board.