Configuration

Basic configuration and activation of a Media Server is accomplished with the commands media_gateway_config and media_gateway_interface (see EXAMPLES section). If the SIP based MSCML protocol (for example for streaming on idle extension) shall be active, also the media_server command must be used.

The media_gateway_config and media_server commands indicate which address of Service Node to contact and control the Media Server. The media_gateway_interface command indicates which addresses Media Server will use for media (RTP). Media and Control (SIP Control or Control Signalling) must use same address and subnet (CIDR) as used for the server in the MX-ONE initial setup. The address type (IPv4 or IPv6) for Control must be same as the preferred address for the Server. Media may have both address types to allow dual stack operation.

Use MS as Media Gateway type (MGU or MS) for Media Server.