ADC - Route Data
Additional Category for External Traffic
Format
ADC = D1D2 ...D28 |
||
D1 = |
Type of Seizure of External Line |
|
0 |
Immediate seizure |
|
1 |
Seizure when minimum number length is attained. (When the whole number shall be sent at the same time (so called enbloc sending), set number length MIN=MAX). |
|
2 |
Seizure when maximum number length is attained, or when minimum number length is attained and time out between digits has elapsed. Used when trunk seizure is not allowed until complete B-number is dialled and the number length is variable, that is, MIN and MAX are different. |
|
D2 = |
Type of Number (TON) See also D19 Type of Called Public Number (B-Number) Used instead of prefix digits (for example 00 for international calls) to indicate to the closest following exchange/network, the type of called public number (of the calls using this destination). |
|
0 |
Unknown public |
|
1 |
International |
|
2 |
National |
|
3 |
Network specific |
|
4 |
Local public |
|
Type of Called Private Number (B-Number) Used instead of prefix digits to indicate to the closest following exchange/network, the type of called private number (of the calls using this destination). |
||
5 |
Unknown private |
|
6 |
Local private Note that this TON requires the use of the RONDI route number data command. |
|
7 |
Level 1 Regional Note that this TON requires the use of the RONDI route number data command. |
|
D3 = |
Type of Calling Public Number (A-Number) Used to control the composing of a complete calling/connected public number to send to the interworking exchange/network. |
|
0 |
Unknown public |
|
1 |
International |
|
2 |
National |
|
3 |
Network specific |
|
4 |
Local public |
|
D4 = |
Type of Calling Private Number (A-Number) Used to control the composing of a complete calling or connected private number to send to the interworking exchange or network. |
|
5 |
Unknown private |
|
6 |
Local private |
|
7 |
Level 1 Regional |
|
D5 = |
Supplementary Services Using UUI (ISDN, H.323) |
|
0 |
Not allowed |
|
1 |
Allowed, only permitted for calls terminating in another MX-ONE or an ASB 501 04. |
|
2 |
Allow informative signalling to MX-ONE gateway for calls to public destinations. |
|
Intra-User (MFE, ISDN) |
||
0 |
No Intra-User (Call over a different network) |
|
1 |
Intra-User** (Call within the same network) |
|
** |
In ISDN trunks, the route must be enabled for net services (see D12 in parameter SIG), to send UUI and charging IBERCOM data (see VARI & VARO for SL60). |
|
D6 = |
Type of Network |
|
0 |
Not fibre route or Transit Network Selection (TNS) |
|
1 |
Fibre route or TNS |
|
D7 = |
Type of Release |
|
0 |
Release when one of the parties goes on hook (terminates the call), that is, first party release. |
|
1 |
Release controlled by A-party, that is, calling party release |
|
2 |
Release controlled by B-party, that is, called party release |
|
D8 = |
Backward Signals for MFC-Signalling |
|
0 |
Send from first digit |
|
1 |
Send next digit |
|
2 |
Repeat latest sent digit |
|
3 |
Send the previous digit |
|
4 |
Send the two previous digits |
|
5 |
No backward signal before direct through-connection |
|
6 |
Received digit(s), and acknowledged digit(s) that have been transmitted, shall be acknowledged before direct through-connection. No signal shall be sent backwards in the network. |
|
7 |
Send from first digit, alternative routing has been executed (CEPT L1 signal) |
|
D9 = |
Terminating and Transit Seizure |
|
0 |
Send terminating seizure signal. Terminating seizure signal means that the call shall be terminated in the next exchange. |
|
1 |
Send transit seizure signal. Transit seizure signal means that the call shall be transmitted through the next exchange. |
|
D10 = |
Threshold Level for OFF-HOOK Queuing |
|
0 |
No threshold level (default value) |
|
1 |
Threshold level 1 |
|
2 |
Threshold level 2 |
|
A search for free route starts with the ordinary route, and if this is busy the call continuous to the first alternative route (Alternative routing). By affiliating a threshold level to the route choice, and comparing this to the call originator's Least Cost Routing Class of Service (LCR COS, see parameter SERV), a route choice can be made more or less exclusive to call originators with higher LCR COS. |
||
Call originators with: A threshold level may only be affiliated to one of the route choices for a destination. LCR COS=3 are not affected by any threshold level setting, they have full access to all route choices. LCR COS=2. When (in the search for a free route choice) the route choice with threshold level 2 is encountered the call is put in queue to the ordinary choice for 8*) seconds. If the ordinary route choice does not become free within this time, a new search is started from the ordinary route choice and continued up to the last alternative route choice. This time with no restrictions. LCR COS=1. When the route choice with threshold level 1 is encountered the call is put in queue to the ordinary route choice for 8*) seconds. A new search is started from the ordinary route choice and continued up to the route choice with threshold level 1. This route choice is not allowed and the call fails. |
||
LCR COS=0. When the route choice with threshold level 1 is encountered the search stops. No queuing is allowed. *) Application system Parameter PARNUM=107 (8 seconds is default). |
||
D11 = |
Sending of Expensive Route Warning Tone (ERWT) |
|
0 |
ERWT not sent (default value) |
|
1 |
ERWT sent |
|
Controls whether or not ERWT shall be sent to the call originator when a selected route choice is seized (except for call originators with TCD category 15). |
||
D12 = |
Least Cost Routing (LCR) |
|
0 |
Available to all calls (default value) |
|
1 |
Available only to calls with LCR facility, and to calls from originators with TCD category 15. |
|
Means that the route choice can be selectively restricted for the calling party. |
||
D13 = |
Sending of Travelling Class Mark (TCM) |
|
0 |
TCM not sent (default value) |
|
1 |
TCM sent |
|
Defines whether or not a calling party's class of service (in form of TCM) shall be sent to the co-operating exchange. Used when the signalling system in the network does not allow sending of calling party's category. |
||
D14D15 = |
Loop Avoidance or Transit Counter |
|
00-25 |
Defines maximum allowed number of transit exchanges a call can be routed through in order to reach the final destination. Default value is 25. |
|
D16 = |
PNR Number Translation Information or LCR Dialled Number Retrieval |
|
0 |
No individual number translation information is available |
|
1 |
Number translation information according to PRE/TRC shall be used (see the LC parameters). |
|
2 |
Number translation information according to PRE1/TRC1 shall be used (see the LC parameters). |
|
3 |
LCR dialled number retrieval (used for the last choice in the RCT). |
|
D17 = |
Type of Protocol to Use for Supplementary Service Call Back or Call Completion |
|
0 |
Proprietary UUI protocol |
|
1 |
Standardized Generic Functional Protocol |
|
D18 = |
Destination Sends B-Answer Signal |
|
0 |
Yes, B-Answer signal is available (default value) |
|
1 |
No, B-Answer signal is not available. Only for specific markets where the connected network offer free-of-charge calls without B-answer. The parameter setting shall only be used for the free-of-charge destinations. This setting generates an internal B-answer, which is required if the call is to be transferred to another extension. |
|
D19 = |
Type of Called Number (TON) See also D2. Normal Case |
|
0 - 7 |
Set D19 to the same value as D2. |
|
When the Route is Used for MX-ONE VPN(VPN without IN Node) and the Public Network Does not Accept Private TONs |
||
0 |
Unknown public |
|
1 |
International |
|
2 |
National |
|
3 |
Network specific |
|
4 |
Local public |
|
D19 shall be set to the same value as D2 except when the route is used for MX-ONE VPN (Virtual Private Network without Intelligent Network node) and the public network cannot handle private TONs. When this is the case the private TON shall be set in D2 (in order to have net services) and a public TON shall be set in D19 (the TON to send to the public network that does not accept private TONs). |
||
D20D21= |
Start Selection Point (SSP) |
|
00 |
Function not in use (default) |
|
01-21 |
Number of digits in a CCSS7 set-up (initial address) message. The digit appointed by the SSP is the last digit included in the message. |
|
| D22 = | Original A-Number |
|
0 |
Diverted party number shall be sent as A-number at external follow-me, personal number deflection, or call deflect/single step transfer (SST) to public party. |
|
1 |
Original A-Number (Calling party number) shall be sent as A-number at external follow-me, personal number deflect, or call deflect/single step transfer (SST) to public part. |
|
D23 = |
Type of Number (TON) of the Original A-Number Only valid if D22 = 1 |
|
0 |
The destination type of number shall be sent as A-number type of number at external follow me or personal number deflection to public party. |
|
1 |
Original A-Number type of number shall be sent as A-number type of number at external follow me or personal number deflection to public party. |
|
D24 = |
Enhanced Sent A - Number Conversion |
|
0 |
Disable conversion |
|
1 |
Enable conversion. If conversion is enabled, the parameter targetdest in the number conversion command must be used. |
|
D25 = |
ISDN: Type of Protocol to Use for Supplementary Service Call Offer (UUI/GFP), or SIP: Handling of Diversion information in transit call scenarios |
|
0 |
ISDN: Proprietary UUI protocol SIP: Do not forward incoming “Diversion” information for SIP-to-SIP calls |
|
1 |
ISDN: Standardized Generic Functional Protocol SIP: Forward incoming “Diversion” information for SIP-to-SIP calls |
|
D26 = |
Emergency Destination |
|
0 |
No |
|
1 |
Yes |
|
Defines if an external destination associated to the existing public route to the PSTN shall be used for emergency calls. Only select Yes when the route is used for emergency calls for IP extensions. |
||
D27 = |
ETSI Diversion supplementary service support towards PSTN (ISDN), or Support of Original Called Address in IAI message for Redirected call (CCSS7) Only valid if D5 = 2 and D22 = 1 |
|
0 |
No |
|
1 |
Yes |
|
D28 = |
Forward switching |
|
0 |
No |
|
1 |
Yes |
|
Defines if forward switching shall be done for all redirection services requested from trunks. (Only relevant for ISDN and H.323). |
||
Function
The parameter states the additional category for an external destination.
Example
Type of seizure of external line |
Seizure when minimum number length... |
Type of called number (B-number) |
National |
Type of calling public number (A-number) |
National |
Type of calling private number (A-number) |
Level 1 Regional |
Supplementary Services using UUI... |
Allowed |
Type of network |
Not fibre route or TNS |
Type of release |
Release when one of the parties goes on hook |
Backward signals for MFC-signaling |
Send from first digit. |
Terminating and transit seizure |
Send transit seizure... |
Threshold level for OFF-HOOK... |
Threshold level 2 |
Sending of Expensive Route... |
ERWT not sent |
Least Cost Routing (LCR) |
Available to all calls |
Sending of Traveling Class Mark |
TCM sent |
Loop avoidance / Transit counter |
Defines maximum allowed numbers of transit... = 03 |
PNR number translation information /LCR dialed number retrieval |
No individual number translation information is available |
Type of protocol to use for Supplementary ... |
Proprietary UUI protocol |
Destination sends B-Answer signal |
Yes, B-Answer signal is available |
Type of called number (TON) |
National (same as D2) |
Start Selection Point (SSP) |
Function not in use |
Original A-Number |
Original A-Number shall be sent |
Original A-Number’s type of number (TON) |
The destination type of number shall be sent |
Enhanced Sent A - Number Conversion |
Enable the Enhanced Sent A - Number Conversion |
Type of protocol to use for Supplementary Service call offer |
Proprietary UUI protocol |
Emergency destination |
No external destination associated to the existing public route to the PSTN shall be used for emergency calls |
ETSI Diversion supplementary service support towards PSTN |
Diverting leg 2 information can be sent to a PSTN.s |
Forward switching |
Forward switching is not used. |
ADC = 1227100012001030002001010010