Fault Code 0:67 - Fault Correcting Common Function Faulty

Fault Code Description

A common program unit often occurs in a version with two editions in the system, one active and one passive as standby. The alarm is obtained when one version of the common program unit not is accessible any longer to the rest of the system.

This is due to that one version of the common program unit is faulty or that the LIM in which one version of the common program unit is located is faulty.

A combination of these causes can, of course, lead to the same fault state.

Measure

1. Has fault code 0:34 arrived in the alarm log?

   For the LIM where the common program is loaded.

2. YES: Go to Fault Code 0:34 - LIM Out of Order.

3. NO: Has fault code 0:50 arrived in the alarm log?

   For the LIM where the common program is loaded

4. YES: Go to the fault locating directions for Fault Code 0:50 - Restart of LIM has Failed.

5. NO: Has fault code 0:44 arrived in the alarm log?

   For the LIM where the common program is loaded

6. YES: Go to Fault Code 0:44 - Reload of Program Code Has Failed.

7. NO: Has fault 0:49 arrived in the alarm log for a program unit in the LIM?

8. YES: Go to Fault Code 0:49 - Restart of Program Unit has Failed.

9. NO: Has fault 0:56 arrived in the alarm log for a program unit in the LIM?

10. YES: Go to Fault Code 0:56 - The System Does not Have an Accessible Backup.

11. NO: Start the system by the command start--system.

12. Was the alarm cleared?

13. NO: Consult an expert.

14. Are there any fault codes left in the alarm log?